Ingeniero electrónico senior

Avionics System Engineer team member
Phase-A activities, Feasibility study, and use of recurring designs of SAOCOM and SABIAMAR satellites missions
Service platform avionics equipment selection.
ECSSS and NASA standards compliant design

System Engineer team member
Requirements analysis
Subsystems Interfaces analysis and compatibility Satellite Electrical Architecture design
Satellite harness designer and responsible
EEE engineering and flight parts purchases from national and international suppliers
Harness crosstraping confiability analysis, FMEA
Harness manufacturing work package schedule management and supervision Team working with others areas: thermal, mechanical and structures, AIT, harness, power, electronics, requirements
Payload module on board computer electronic hardware responsible
ECSSS and NASA standards compliant design

Roles: EGSE System Engineer team member
EGSE Electronic Ground Support Equipment, architecture analysis and development
ECSSS and NASA standards compliant design

Work packages design and management
SAR Radar signal and synchronism generator Module requirements analysis
EEE Flight parts selection with national & international purchases
Multifrequency RF frequency synthetizer design, with optimization of leakage current, phase noise, jitter and spurious signals.
STALO conformer signal clock circuit design and start up
L-Band RF High power amplifier design and start up
High power amplifier control module design and start up
L-band amplifiers Multipactor analysis and mitigation techniques.
Multipactor Thermovacuum tests performed at ESA-VSC laboratories, Valencia, Spain
SAR antenna RF loop characterization procedures development Confiability analysis
RF laboratory instrumental management
Thermal, TVAC ,EMI EMC tests
WCA, FMEA
ECSS and NASA standards compliant design

Power and radiofrequency Electronic boards start up
Electronics laboratory radiofrequency measurements

Service Platform power subsystem team member :
EEE Flight parts selection with national & international purchases
Electronics boards design, development and start up
Equipments electronic Intefaces analysis
Confiability analysis,WCA, FMEA
Satellite Electronic boxes integration and measurement procedures development
ECSSS and NASA standards compliant design

1.5 MWatt DFIG Wind turbine feasibility and vectorial operating principle study

Mantenimiento de instalaciones eléctricas y electrónicas de potencia

Instalación y reparación de instrumentación industrial para compañías petroleras. Reparaciones e instalaciones eléctricas

Instalación y reparación de instrumentación industrial para compañías petroleras.
Reparaciones e instalaciones eléctricas

Programador en Visual Basic

INGENIERO ELECTRONICO